Keep water from escaping onto the bathroom floor with shower door seals and sweeps from the professionals at C.R. Laurence. We offer a variety of shower hardware design options to fit many different home and bathroom styles. For example, trendy black grid shower doors look sleek and modern when paired with the right bottom shower door sweep. These seals can also be equipped with V-seal weatherstripping, a bulb seal, T-seal, or L-bar sealer to prevent leaks.
Customization is key, so CRL offers options such as frameless shower door seals for a clean, minimalist look, swinging shower door bottom seals for hinged doors, sliding shower door seal strips for bypass systems, fin seal weatherstripping for tight water control, shower jamb weatherstripping for gaps at door edges, and drip rails for directing water flow back into the shower. This helps to ensure waterproofing at the doors and corners. CRL also offers a large selection of shower door sweeps to choose from that snap to the edges of frameless shower doors and keep water from dripping out of the shower.
Seals, Wipes, Drip Rails, Jambs, & Grids FAQ
How long should a shower door seal last?
The longevity of a
shower door seal depends on how often it is used and how well it is maintained. Provided it is cared for regularly, experts suggest replacing shower door seals every 2-3 years. Signs that a shower glass door seal needs to be replaced include stretching, leaking, discoloration, gaps, and cracking. To make shower seals last longer, clean them regularly, about once per week, using a gentle cleaner to remove any mineral buildup. Investing in a higher-quality shower door bottom seal can also make it last longer, sometimes up to 5 years. The frequency at which a shower is used and the quality of the water itself can also contribute to a shower seal’s lifespan; hard water with high mineral content is rougher on seals and can cause the need for replacement sooner.
How do you replace a shower door sweep on a glass shower door?
There are a few basic materials and steps to follow when replacing an old shower door sweep or
drip rail on a glass shower door. Gather supplies, including the replacement shower door sweep, and measure the door first to ensure correct sizing. Other materials needed include a knife or scissors, rubbing alcohol or glass cleaner, a soft cloth, and a rubber mallet or small hammer. Remove the old door sweep by sliding it out of the groove. Use cleaner or rubbing alcohol to clean where the door sweep attaches. Hold the replacement sweep up to the door; if it is too long, cut it to size with a utility knife or scissors. Install the new door sweep by either sliding it into place (use a rubber mallet or hammer wrapped in cloth to tap it into position gently, if desired), or press the sweep onto the door if it is an adhesive sweep.
How do you install a shower door drip rail?
No one wants water dripping from the shower area onto the bathroom floor. Keep bathrooms clean and dry by installing
shower door drip rails. First, use glass cleaner or rubbing alcohol to clean the bottom of the shower door. Next, measure the rail against the door and cut it to size, if needed. Align the rail along the door’s bottom edge with the lip facing inward. Attach the drip rail either using adhesive backing (pressing firmly onto the door) or using screws and a drill. If desired, apply a silicone sealant along the edges for additional waterproofing. Finally, be sure to test the shower door drip rail while the water is running. Open and close the door to ensure proper functionality.